Performance Improvement of Vapour Compression Refrigeration System with Phase Change Material
Ajit Wagh, B. S. Gawali
Corresponding Author : Ajit Wagh
Walchand College of Engineering, Sangli 416415, Maharashtra, India
Email ID : firstname.lastname@example.org
Received : 2018-06-29 Accepted : 2018-08-23 Published : 2018-08-23
Abstract : Efforts to increase energy efficiency of refrigeration system shall directly reduce energy consumption. The phase change material stores the latent heat, this latent heat is utilize for heat leak from evaporator cabinet. Phase change material (PCM) is a new approach to improve the performance of refrigeration system. The refrigeration system has been tested with different PCMs Eutectic solution of melting point 0 to -5°C respectively. The three phase change materials has been tested and the observation for temperature stability has been tested, also the effect of phase change material on COP of the system has been tested. Experimental results show that when compressor is cut off the system with PCM maintains the desired temperature than without PCM. Also the COP is high if PCM is used than without PCM .In this study it shows that using phase change materials in refrigeration system is vary energy saving method.
Keywords : PCM, Eutectic solutions, VCR, COP
Citation : Ajit Wagh et al. (2018). Performance Improvement of Vapour Compression Refrigeration System with Phase Change Material, J. of Advancement in Engineering and Technology, V6I4.06. DOI: 10.5281/zenodo.1402364. DOI : 10.5281/zenodo.1402364
Copyright : © 2018 Ajit Wagh. This is an open-access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.
Journal of Advancement in Engineering and Technology
ISSN : 2348-2931
Volume 6 / Issue 4
ScienceQ Publishing GroupDownload Article
Reviewer Comments : Reviewers comments section of this article will get update shortly.