Research Article
Performance Analysis of Microchannel Heat Exchanger in Vapour Compression Refrigeration System
Akash Katakdhond, B. S. Gawali
Corresponding Author : Akash Katakdhond
Walchand College of Engineering, Sangli 416415, Maharashtra, India
Email ID : akashkatakdhond13@gmail.com
Received : 2018-06-29 Accepted : 2018-08-23 Published : 2018-08-23
Abstract : The purpose of the present study is to develop a setup of a vapor compression refrigeration system operating on low GWP refrigerant i.e. Refrigerant R134-a. Also the important part evaporator construction for maintaining future high- performance microprocessor chips within an acceptable operating temperature range. This requires removing a large quantity of heat, from smaller areas. The present study reports on an experimental evaluation of flow boiling of R134a inside a rectangular microchannel heat sink. The copper test section of parallel rectangular channels is used for the study. The experiments are to be performed with a direct circulation of refrigerant through the microchannel. The wall heat flux can be increased from 12 kW m−2 until reaching critical heat flux.
Keywords : microchannel, heat flux, compressor, condenser, capillary tube
Citation : Akash Katakdhond et al. (2018). Performance Analysis of Microchannel Heat Exchanger in Vapour Compression Refrigeration System, J. of Advancement in Engineering and Technology, V6I4.05 DOI : 10.5281/zenodo.1402273
Copyright : © 2018 Akash Katakdhond. This is an open-access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.
Journal of Advancement in Engineering and Technology
ISSN : 2348-2931
Volume 6 / Issue 4
ScienceQ Publishing Group

Reviewer Comments : Reviewers comments section of this article will get update shortly.