Research Article
Design and Implementation of a Remote Controlled Car Jack
Egwerome Oghenekome, Oladimeji Tolulolope, Oshevire Patrick
Corresponding Author : Oshevire Patrick
Department of Electrical-Electronics, College of Technology, Federal University of Petroleum Resources, (FUPRE), Effurun, Warri. Delta State, Nigeria.
Email ID : ask4pat2001@yahoo.com
Received : 2014-01-15 Accepted : 2014-01-30 Published : 2014-01-30
Abstract : This paper would involve designing the system and also constructing a unit that can be used to jack up any regular car as controlled by the transmitter to the receiver. The receiver circuit would be controlled by microcontroller. It also involves the designing an infra-red transmitter circuit capable of transmitting a coded frequency. The receiver circuit would be able to receive the transmitted infra-red beam and be able to process and decode the control signals for the upward movement of the jack. The control mechanism consisting of the dc motor and the link mechanism would be arranged such that it will allow for smooth control and well fabricated and attached to the hydraulic jack. The complete unit should be able to raise up loads placed on it.
Keywords : Interface, Microcontroller , Multivibrator, Screw jack, Transmitter
Citation : Oshevire Patrick(2014) Design and Implementation of a Remote Controlled Car Jack. j.Advancement in Engineering and Technology.V1I1.09. DOI : 10.5281/zenodo.1000368
Copyright : © 2014 Oshevire Patrick, et al. This is an open-access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.
Journal of Advancement in Engineering and Technology
ISSN : 2348-2931
Volume 1 / Issue 1
ScienceQ Publishing Group

Reviewer Comments : Reviewers comments section of this article will get update shortly.